4 Steps use Silk'n™ IPL hair removal home devices
Step 1 : Cleanse, shave, and towel-dry the skin, then wipe the area with a cool towel
For the Best results, the hair should be no longer than 1 or 2 mm in length. You have to avoid removing the entire hair follicle like with waxing or sugaring six weeks before using, otherwise the light won't have hair to target.
Step 2 : Setting level
Silk'n™ has five settings, going from lowest to highest in the amount of heat and light it gives off. For your first 50 shots, it will only allow you to use the lowest setting. After the first 50, the next 200 shots will only go up to level three. The Level 5 is most effective for hair removal but also the most painful.
Step 3 : Apply and over laser treatment
Place the Silk'n™ on your skin and press the head of the device down fully and then press a button, it beeps and lets off a bright light like when you take a picture. The bright light will not harm the eyes when applied to non-facial sites, and special eye-protection is not needed.
Each treatment, which can be completed in as little as five minutes for the underarms and in 30 minutes for the lower legs, should be performed once every other week in the initial phase, and then as needed thereafter. When a pulse of light is activated, it is normal to hear a subtle pop sound simultaneously with the flash of light. While the cooling fan in Silk'n makes a noise similar to a hairdryer. This is normal.
Step 4 : Future treatments
After about 2 weeks the hair started to eject out and continued to do so. Usually, sessions 5 - 7 are typically 4 weeks apart.